1. Before each program processing, it is necessary to strictly confirm whether the tools are consistent with the program.
2. When installing the knife, you must confirm the length of the tool and whether the chip knife header is appropriate.
3. During the operation of the machine tool, the door is prohibited to avoid flying knives or flying engines.
4. During the processing process, the operator of the knife must be parked immediately, such as pressing the "Emergency Stop" button or the "Reserture button" button or zero the "feed rate" to zero.
5. In the same workpiece, each time the knife is kept in the same area to ensure the operation rules of the accuracy CNC processing center when the knife is connected.
6. If the amount of processing is too much during processing, you must use the "single section" or "suspension" to manually apply it to the X, Y, and Z numerion after clearing it. run.
7. In the self -operating operation, the operator shall not leave the machine or check the operating conditions of the machine regularly. If you need to leave halfway, you must specify the relevant personnel to check it.
8. Clean the aluminum residue in the machine to prevent aluminum residue from absorbing oil.
9. Try to blow air in the rough program and spray fuel in the light knife program.
10. After the workpiece is picked up, the burrs must be cleaned in time.
11. At the time of get off work, the operator must handle accurate transfer in time to ensure that subsequent processing can be carried out normally.
12. Before shutting down, ensure that the knife library is in the original position, the XYZ shaft is parked in the center position, and the power and total power supply on the machine tool operating panel is turned off in turn.
13. When encountering thunderstorms, you must immediately cut off the power to stop the work.

In addition to the above points, there are many things that we need to pay attention to. Regular machine maintenance, do not pay attention to checking the machine before booting, do not warm up, some companies are in dark and humid, dusty, oil and various other chemical liquids due to the poor environment. It is easy to cause problems with the machine. In fact, if these problems are dealt with in time, then our machine uses a lot of useful life, and the processing accuracy and performance of the machine will be as new as possible, and the loss will be greatly reduced. The replacement frequency of components is reduced, saving a lot of time and cost

If there is any abnormal phenomenon during operation, please contact the manufacturer in time to avoid unnecessary losses.